hishutup Posted October 9, 2014 Share Posted October 9, 2014 (edited) Use this Topic to post generic Oblivion questions when following any of the Oblivion guides. Be sure to check the FAQs. I will be updating it as questions are asked. I'll try to populate my Troubleshooting section on my FAQs page with common problems with Oblivion and Wrye Bash. Edited October 10, 2014 by hishutup Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 I ran the test and everything turned out fine :( Im at a loss for what is causing it. Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 (edited) I ran the test and everything turned out fine :( Im at a loss for what is causing it.Did you know that burn-in tests are supposed to be run continuously for 24 hours? Another possible avenue is to stress-test your GPU. https://www.geeks3d.com/gputest/ Edited July 30, 2016 by pmw57 Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 So I used the burn stress tool again your posted. I have no errors but when it finishes at the end, my comp crashed and I have to restart it. It won't let me boot up windows until turning it off and leaving it off for a while and when I finally do get it on my ssd becomes full of space when I should have about 200 gigs left. Would that indicate a ssd problem?Did you know that burn-in tests are supposed to be run continuously for 24 hours? Another possible avenue is to stress-test your GPU. https://www.geeks3d.com/gputest/really? it said 15 minutes remaining when I tried to run it so I figured it was only 15 mins long Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 (edited) So I used the burn stress tool again your posted. I have no errors but when it finishes at the end, my comp crashed and I have to restart it. It won't let me boot up windows until turning it off and leaving it off for a while and when I finally do get it on my ssd becomes full of space when I should have about 200 gigs left. Would that indicate a ssd problem?Yes, I think that it would indeed. really? it said 15 minutes remaining when I tried to run it so I figured it was only 15 mins longAhh, that will be the free version limitation. I think that there are other burn-in tests that run properly longer. Most hard drive manufacturers provide stress-testing software for their devices from their website. Edited July 30, 2016 by pmw57 Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 Welp I'll get me a nice samsung 500gb evo on payday this week then. Guess I willHave to keep myself occupied until then lol. Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 Welp I'll get me a nice samsung 500gb evo on payday this week then. Guess I willHave to keep myself occupied until then lol.Not to burst your bubble, but the reason for such excessive stress testing is to gather confirming evidence about may be at fault. It would be quite a shame to go to the expense of a new hard drive only to find that you still have the same problem, because that wasn't what was causing the issue in the first place. Good luck. Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 (edited) Not to burst your bubble, but the reason for such excessive stress testing is to gather confirming evidence about may be at fault. It would be quite a shame to go to the expense of a new hard drive only to find that you still have the same problem, because that wasn't what was causing the issue in the first place. Good luck.True. I'm seriously about to replace my whole rig lol. I just want a damn stable game. I put this thing together not even a year ago too. The only old parts my ssd, hard drive and power supply. All 3 of those about 5 years old now. I appreciate your help man. Edited July 30, 2016 by Scythiss Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 (edited) Hey @hishutup I have something for you. You know the issue that Alive Waters Updated causes when you rebuild the Bashed patch, and you get a python warning with: mgef: RawMGEFCode(RSWD) mgef not found in bush.mgef_nameThat's caused by two ingredients, herring fillet and eel flesh, that each contain a reference to Resist Water Damage, which doesn't exist anymore.Removing that effect from each of the ingredients allows the rebuild to proceed without any trouble. I put the details in this post in their forum thread. Edited July 30, 2016 by pmw57 Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 pmw57 everytime I use that tool you link me to, to test my rig my comp crashes when it finished and then my computer will not boot up because it does not recognize my ssd unless I leave my computer turned off for a while. I'm 80% sure my ssd is probably screwed up. I've been dealing with all kinds of crazy thing on my comp in the past year or so. Files fail to write to my ssd, comp takes forever to start up. Been gettings Bsod for the past year when leaving my comp idle even after reformatting. Even when I reformat and I test my system for corrupt files, It says I have tons of corrupted windows files. Not sure if everything I listed is symptoms of an ssd issue, but I guess we will see when my new one arrives in a few days. Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 (edited) Hey @hishutup I have something for you. You know the issue that Alive Waters Updated causes when you rebuild the Bashed patch, and you get a python warning with: mgef: RawMGEFCode(RSWD) mgef not found in bush.mgef_nameThat's caused by two ingredients, herring fillet and eel flesh, that each contain a reference to Resist Water Damage, which doesn't exist anymore.Removing that effect from each of the ingredients allows the rebuild to proceed without any trouble. I put the details in this post in their forum thread. And knight spines! Herring fillet, eel flesh, and knight spines all contain the reference to RSWD that's causing the problem. pmw57 everytime I use that tool you link me to, to test my rig my comp crashes when it finished and then my computer will not boot up because it does not recognize my ssd unless I leave my computer turned off for a while. I'm 80% sure my ssd is probably screwed up. I've been dealing with all kinds of crazy thing on my comp in the past year or so. Files fail to write to my ssd, comp takes forever to start up. Been gettings Bsod for the past year when leaving my comp idle even after reformatting. Even when I reformat and I test my system for corrupt files, It says I have tons of corrupted windows files. Not sure if everything I listed is symptoms of an ssd issue, but I guess we will see when my new one arrives in a few days.Excellent! I could not have asked for a more reliable way to demonstrate that your hard drive is buggered and needs to be replaced ;-) Edited July 30, 2016 by pmw57 Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 So because my ssd is down for the count, I did a clean install of windows 10 on my hard drive and I'm still getting the same CTD. I've seen that Microsoft Visual C++ Runtime Library Redistributable Package 2015 x86and Latest version of DirectX 9.0c (June 2010) is required. I'm going to try to install that and see if anything changes. Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 So because my ssd is down for the count, I did a clean install of windows 10 on my hard drive and I'm still getting the same CTD. I've seen that Microsoft Visual C++ Runtime Library Redistributable Package 2015 x86and Latest version of DirectX 9.0c (June 2010) is required. I'm going to try to install that and see if anything changes.Don't even bother testing Oblivion yet until you have confirmed that the system changes you've made result in a more stable computer system. Use the tsts that showed your SSD was so sad, for example.It might be that the SSD is not the root cause for example. Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 (edited) Don't even bother testing Oblivion yet until you have confirmed that the system changes you've made result in a more stable computer system. Use the tsts that showed your SSD was so sad, for example.It might be that the SSD is not the root cause for example.For sure. I'm going to give this another go on a laptop and see if I can get any CTD's but I swear I had none after testing it like 20 different times on the laptop. Edited July 30, 2016 by Scythiss Link to comment Share on other sites More sharing options...
0 Scythiss Posted July 30, 2016 Share Posted July 30, 2016 I know hishutup was able to reproduce the CTD, so at least that makes my claims some what sane. I also don't know what changes I should make to have a more stable comp. Everytime I run that test I get 0 errors but at the end when it finishes it makes my comp crash. Link to comment Share on other sites More sharing options...
0 pmw57 Posted July 30, 2016 Share Posted July 30, 2016 (edited) I know hishutup was able to reproduce the CTD, so at least that makes my claims some what sane. Was he? Last I saw he has said two significant things about it, nothing confirming the CTD on his part yet. First, when you provided your step-by-step install process: oh, that is weird.I'll have to look into it a little bit more but Scythiss isnt 100% crazy.It must be a spawn or something. and later when you questioned him further: I just havent investigated it. My guess is that there some thing with a bad mesh. Edited July 30, 2016 by pmw57 Link to comment Share on other sites More sharing options...
Question
hishutup
Use this Topic to post generic Oblivion questions when following any of the Oblivion guides.
Be sure to check the FAQs. I will be updating it as questions are asked.
I'll try to populate my Troubleshooting section on my FAQs page with common problems with Oblivion and Wrye Bash.
Edited by hishutupLink to comment
Share on other sites
Top Posters For This Question
150
94
72
25
Popular Days
Aug 6
25
Jul 24
24
Jul 30
21
Jul 31
20
Top Posters For This Question
Scythiss 150 posts
pmw57 94 posts
hishutup 72 posts
SynthetikHD 25 posts
Popular Days
Aug 6 2016
25 posts
Jul 24 2016
24 posts
Jul 30 2016
21 posts
Jul 31 2016
20 posts
Popular Posts
Scythiss
lower heap size until game starts.
Scythiss
OOO does not like the new version of OR. Crashes from horn cave to ill omen every time, Just a heads up for everyone.
pmw57
It applies a custom sort to the list. See https://boss-developers.github.io/BOSS%20Readme.html#gui-urm for details on how to use it.
459 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now