Strange water glitch when using ENB with MO in Fallout 3

[DimestoreDeity]

I have this glitch when using an enb with MO.  What appears to be a layer of water texture overlays a chunk of Megaton.  When I start the game with the .exe ENB loads and there is no glitch but if I use MO to start the game, even when I've disabled all mods, the glitch appears.  Does anyone know what might be causing this?

enb 2014_07_16 19_38_033_35.bmp

[EssArrBee]

I'm pretty sure that this is known issue. I've seen it on the ENB forums a few times, you might check there for a solution.

[DimestoreDeity]

There are reports of a very similar issue with ENB but those don't have anything to do with MO and instead have to do with confilcts with vanilla fallout.  The ENB runs fine if I don't use MO.

[Nozzer66]

I seem to recall seeing that happen once when I'd forgotten to turn off AA and so on in the actual FF3 launcher.

[DimestoreDeity]

I have AA and AF turned off but the glitch only appears when using MO and does not appear when I run the game normally, even when using identical settings.

[DimestoreDeity]

I reinstalled all the mods with Nexus Mod Manager and started the game and the glitch was not present, fairly conclusively proving it is a conflict with MO.  Very curious what's causing it.

[FalloutAddict]

I've got the same problem. I will try using FOMM and see what happens. 

Edited October 16, 2014 by FalloutAddict

[Nozzer66]

I recently again redid FO3 and ran into this issue. I'd followed Kelmych's guide, except for ENBoost, knowing I'd add an ENB at the end.

 

When I started over and added the ENB files at the time Kelmych's guide suggests adding ENBoost, the problem didn't occur. Was using MO.

[hishutup]

There is a mod(s) you have to disable and save then re enable it...

I can't remember which but I do remember is was a strange effect from the problematic mod