Skylight ENB: FPS Drop on Area Transition

[Guest]

Hello,

 

I recently updated to STEP 2.2.9 and run Skyrim through Mod Organizer using SKSE. I noticed that after I installed Skylight ENB everything runs great until I either fast travel or load out to Skyrim from inside of an interior cell. My framerate outside, which typically stays high 30s to low 40s, drops down to mid to high teens.

 

I'm able to fix this by alt-tabbing out of the game and going back in. It almost seems like a memory issue of some sort.

Do you guys have any ideas?

 

System Specs:

Intel i5 3.4Ghz

Geforce 660TI 2GB

16GB DDR3 RAM

[Guest]

Could you recommend a good anti-aliasing method to use with an ENB? I know that will impact FPS but perhaps if I lower the shadows to 1024 the additional frame rate I'd gain will even out in the end. I know there are several different kinds, but since the card you're using is similar to mine, I figure if you're using a certain method that works it should run fine on my system as well. (unless you aren't using any at the moment)

Edited July 26, 2014 by Kessno

[Aiyen]

I am at 1440p which provides enough pixels to not really have much aliasing. But SMAA is the most used method I would say. It also come with somewhat adjustable quality/performance. The other alternative is FXAA. They both work the same way by adding the name of the AA technique .dll to the enblocal proxy entries and then use it. 

 

The little bit of AA I require I get via the edge AA from ENB. Some do not like the blurring it does.. but I kinda do since it helps make trees look more full.