Discrepancy to your recommendation about Display section on INI

[TKHBMVP]

Just used Launcher and disabled the settings for MultiSampling and Ansisotrophy Filter on a start from scratch and new discovery of hardware and go figure, disabling this settings sets them to 1 on the INI, not 0.

 

From this guide
https://wiki.step-project.com/Guide:SkyrimPrefs_INI/Display
it says that 0 is off and 1 is low setting? May be you need to be more specific about the off setting for this entries.

 

[DoubleYou]

Just used Launcher and disabled the settings for MultiSampling and Ansisotrophy Filter on a start from scratch and new discovery of hardware and go figure, disabling this settings sets them to 1 on the INI, not 0.

 

From this guide

https://wiki.step-project.com/Guide:SkyrimPrefs_INI/Display

it says that 0 is off and 1 is low setting? May be you need to be more specific about the off setting for this entries.

Both 0 and 1 are off. So is 5, 7, 9, and 22, etc., if I am correct (I haven't gotten this far yet in my experimenting). What that is saying is that the Default value is 0 (off), the Low PRESET is 1 (also off), medium preset is such and such and so on. I shall attempt to make this more clear in the INI guides.