TZV4344
-
Posts
7 -
Joined
-
Last visited
TZV4344's Achievements
Thane (4/12)
0
Reputation
-
I ran the program with Verbose=0 and the generation was completed in about 30 minutes. I am not sure how long I have had this setting turned on, but I will turn it off in the future. Thank you very much. I will submit the LOG just in case. https://ufile.io/gaaze14u
-
This is a log to help you confirm the issue of Alpha167 taking too long to generate. Generation stopped after about an hour. I uploaded the log at that point. https://ufile.io/4qs3huw0
-
I followed the update procedure. Perform a completely new installation, but not overwrite, and modify the configuration files for the new version without copying the configuration files. Then use winmerge to do a diff comparison with the old version to make sure you are not using a different configuration. I was using in alpha165. And even if I run it with the exact same configuration and mods as alpha165, alpha167 takes an unusually long time. I have read the page on memory usage and if I am using the exact same settings as alpha165 where the memory usage trends were normal, do I need to change the settings in alpha167? I will submit the logs as soon as I finish, but I am not entirely sure when the generation in alpha167 will be finished, so I would appreciate it if you could wait. P.S. I decided to stop the generation once, set RealTimeLog=1, and run it again to log the data.
-
Another person reported a very long run time issue with Alpha166 a few days ago, and after trying with Alpha167, I don't think the issue has been resolved yet. If I use a mod list and settings that take about 35 minutes to generate in Alpha165 and then generate in Alpha167, the generation does not finish even after 90 minutes (it is still generating as I write this). (It is still generating as I write this, and I don't know when it will finish.) In addition, it is frequently using up to its on-board memory limit. This did not happen with Alpha165. However, generation does not stop due to lack of memory.
-
I was going to post the log when I got home, but it seemed to be exactly the problem that was fixed in alpha-110. Thanks for the update.
-
First of all I would like to apologize for any rudeness in my wording as I use DeepL. Perhaps the load order checking method has changed since Alpha109, but I am getting errors in profiles where no problems were detected in 108. I would like to try to correct it to the correct load order, but where should I look in the log?
