Dobby061994

I figured out what was causing this, it turns out I misunderstood the dropdowns in the terrain LOD section. I thought I only had to pick one, so I only input the settings for LOD32 thinking that would result in the highest level of quality. After realising I ran LODGen again using all the settings for LOD4, LOD8, and LOD16 as well and now it's all fixed. My mistake! Perhaps a text edit in the STEP guide to clarify that all 4 dropdowns need to be configured would help people not make the same rookie error? Regardless, thank you for the reply.

Hi, I've followed the STEP guide for Fallout 4 extremely closely and got right to the end where I'm ready to launch the game and configure mods via the in game MCM, but when I walk around Sanctuary Hills some of my LODs haven't generated correctly: https://imgur.com/a8IRllZ You can see on the right that the hillside rocks and the billboard are both very blocky and blurry, and the electricity pylons especially are partially see-through and haven't fully loaded. Once I get closer the LODs load normally, but revert to this again when I move away, and just from walking around I can observe that pretty much all kinds of LODs aren't loading until I get quite close. I've included every single LOD-related mod/resource and followed the STEP guide to the letter. I've tried deleting all my TexGen and LODGen files and regenerating them all from scratch using the recommended settings again but no luck unfortunately. I've also read from some other posts on here that sometimes this game doesn't like much newer hardware that it can't auto-detect? My PC specs are: Ryzen 7800X3D 32GB DDR5 RAM 6000MHz RTX 4080 2TB Kingston NV2 SSD Windows 10 Would greatly appreciate any help. EDIT: I should add that I didn't get any error messages when running LODGen either, it all completed successfully but the end result looks as described.