Guide:ENBSeries: Difference between revisions
From Step Mods | Change The Game
TechAngel85 (talk | contribs) |
TechAngel85 (talk | contribs) (→BLOOM) |
||
Line 1,074: | Line 1,074: | ||
BlueShiftAmountInteriorNight=(0.0...10.0)</pre> | BlueShiftAmountInteriorNight=(0.0...10.0)</pre> | ||
== LENS == | |||
== | |||
{{Notice Small|Completely outdated. DO NOT USE!}} | |||
This is for simulating lens distortion and reflection in cameras which is part of the bloom code; thus, it requires having bloom enabled in order to work. The amount of lens reflection is dependent on the amount of bloom. | This is for simulating lens distortion and reflection in cameras which is part of the bloom code; thus, it requires having bloom enabled in order to work. The amount of lens reflection is dependent on the amount of bloom. | ||
Line 1,081: | Line 1,083: | ||
LenzReflectionPower - controls how much of the effect is displayed depending on light levels during the day, night, and in interiors. Lower values cause the effect to be mirror-like and higher values will cause the effect to be glare-like. | LenzReflectionPower - controls how much of the effect is displayed depending on light levels during the day, night, and in interiors. Lower values cause the effect to be mirror-like and higher values will cause the effect to be glare-like. | ||
== Editing Camera Effects == | |||
These setting will adjust the amount of lens effects added, and will trigger when looking at a bright surface, like the sun. This section will not do anything if there is no Bloom added or if it is disabled. | |||
The following parameters determine the intensity of the lens effects when looking at bright surfaces. The settings go from 0.0 to 10.0. If using an ENB Profile then it is recommended to not change these settings. | |||
<pre>LenzReflectionIntensitySunrise=(0.0...1.0) | |||
LenzReflectionIntensityDay=(0.0...1.0) | |||
LenzReflectionIntensitySunset=(0.0...1.0) | |||
LenzReflectionIntensityNight=(0.0...1.0) | |||
LenzReflectionIntensityInteriorDay=(0.0...1.0) | |||
LenzReflectionIntensityInteriorNight=(0.0...1.0)</pre> | |||
This is the sensitivity of the lens effect where higher values create lens reflections only for bright light sources. Values lower than 1 will generate reflections. The settings go from 0.5 to 10.0. If using an ENB Profile then it is recommended to not change these settings. | |||
<pre>LenzReflectionPowerSunrise=(0.0...10.0) | |||
LenzReflectionPowerDay=(0.0...10.0) | |||
LenzReflectionPowerSunset=(0.0...10.0) | |||
LenzReflectionPowerNight=(0.0...10.0) | |||
LenzReflectionPowerInteriorDay=(0.0...10.0) | |||
LenzReflectionPowerInteriorNight=(0.0...10.0)</pre> | |||
<!-- | |||
== SSAO_SSIL == | == SSAO_SSIL == |
Revision as of 16:04, September 3, 2014
Template:Notice A comprehensive guide for properly setting up ENB for n00bs and gurus alike -- by the S.T.E.P. Team