Launching the game after Extenders is installed, wrong resolution (I think)

[Halde]

Hi all!
 

Just done with my installation of Extenders. The game loads fine in Riverwood, nothing there, however it doesn't load in fullscreen. Now I remember the guide says windowed mode in bethini i think it was, but I seem to recall it being windowed fullscreen the previous times I've installed the guide. I thought maybe this has something to do with resolution, as my display is 1440p, but I followed the guide, choosing 1080p. Is this something that is later adressed, and should I move on with the guide, or is this something that need fixing now?

~Sincerely

Halde

[z929669]

2 hours ago, Halde said:

Hi all!
 

Just done with my installation of Extenders. The game loads fine in Riverwood, nothing there, however it doesn't load in fullscreen. Now I remember the guide says windowed mode in bethini i think it was, but I seem to recall it being windowed fullscreen the previous times I've installed the guide. I thought maybe this has something to do with resolution, as my display is 1440p, but I followed the guide, choosing 1080p. Is this something that is later adressed, and should I move on with the guide, or is this something that need fixing now?

~Sincerely

Halde

Revisit this step of the guide. You are only smoke testing and not actually loading the game for play at this point. You are only testing that the you can load the game and COC to Riverwood. Nothing more.

[Greg]

I think the confusion is that in the BethINI Baseline Configuration it states to "Configure BethINI as described in the steps below, which are reflected in the images where applicable. Please do no deviate from these instructions at this time:" and the first screenshot has Resolution: 1920x1080. It's not clear whether users should force 1920x1080 or use their native resolution, although I assume the intention is to use the native resolution (1920x1200 in my case or 2560x1440 in Halde's case)?

[z929669]

9 minutes ago, Greg said:

I think the confusion is that in the BethINI Baseline Configuration it states to "Configure BethINI as described in the steps below, which are reflected in the images where applicable. Please do no deviate from these instructions at this time:" and the first screenshot has Resolution: 1920x1080. It's not clear whether users should force 1920x1080 or use their native resolution, although I assume the intention is to use the native resolution (1920x1200 in my case or 2560x1440 in Halde's case)?

Yes, it should be native resolution. I'll correct that.

[Halde]

Yes, Greg, that was exactly the confusion! 

Thanks for the answers both!